Payment & Shipping Terms:
|Pumping Motor:||380V/7.5kW||Pump Core:||L1|
|Allowed Max. Aggregate Diameter:||6mm||Material Theoretical Output:||20 - 40 L/min|
|Conveying Pressure:||25 - 40 Bar||Mixer Capacity:||120L|
|Feature:||Wet Model Plastering Machine|
gypsum plastering machine,
cement sprayer machine
The mortar spraying machine is a Screw Pump high-pressure mortar spraying machine, with advanced technology, simple operation and maintenance, it can be operated skillfully without special training. It's adapted spraying material included: putty powder, paint, latex paint, lacquer, cement mortar, dry mortar, thermal insulation, waterproofing materials, fireproof materials, insulation materials, sound-absorbing materials and other water-soluble material.
1.The Plastering Machine is a new desinged multi-functional plastering equipment.
2.The Plastering Machine can be used for pumping and spraying ready-mixed mortar material, such as cement mortar, lime plaster, gypsum plaster, masonry mortar.
3.The Plastering Machine can be used for plastering fluid materials, such as thermal insulation material of walls, refractory material, fire-proof material, water-proof material, acoustic material, water soluble etc.
1.Basically no ash falls, water, and material, the cost can be reduced more than 20%;
2.Co-mortar operations, such as cement mortar, but also for paint, lacquer, relief effect coatings, waterproofing materials, refractory materials, such as spraying operations, is used for housing protection, paint, paste on the bottom of suitable models
3.Simple operation; speed, high efficiency, low labor intensity
4.Project quality assurance; a multi-purpose machine that can spray mortar, fire protection materials, refractory materials.
5.It carries with an air compressor.
1.The dry materials is supplied in sacks and filled into the large hopper.the low height of the machine makes filling considerably easier.
2.The materials is then transported by the agitator out of the hopper into the mixing pipe of the machine.
3.The particular geometry of the agitator means the hopper can be emptied almost 100%.in the mixing area.the amount of water appropriate to the materials is supplied. depending on the mortar used.the amount of water can be separately regulated.
4.The mixing area is extremely large. this means the material is perfectly mixed and reaches the rotor/stator pump of the machine in an ideal condition.
5.There it is then pumped at pressure through the mortar hose.the nozzle is connected in the end of mortar hose with compressed air and then the mixed mortar is sprayed out evenly.
6.The integrated mini compressor ensure the air pressure and consumption always adequate. as well as remote-control by air valve.attention for detail instruction .please follow the operation manual.